Since the development of the laser industry, it has been involved in industrial, medical, intelligent manufacturing, communications, aerospace, hardware processing, 3C electronics, daily chemical industry and other industries that use laser marking machine in processing. Any equipment has a service life, and sometimes our inadvertent operations may reduce the life of the equipment, so how can we avoid these operations? Let's take a closer look.

     1, before using the laser marking machine, pay attention to the order of each turn on the device: turn on the power switch; Open the high-power fully cured laser and laser special, the use of laser marking machine process principle and semiconductor laser marking machine at this time the machine ventilation and refrigeration system power, ammeter display value of about 7A; Wait 5-10 seconds, press the trigger button on the external control panel, the ammeter display value is zero, after 3-5 seconds, the ammeter display value is 7A; Open the galvanometer power supply; Open the computer and pull out the required marking file; Adjust the laser power supply to the operating current (10-18A), and then start marking. The shutdown sequence is reversed.

     2, replace the circulating water and clean the water tank: clean up once a week, replace the water inside, the circulating water is too long for the machine, the water quality and water temperature of the circulating water directly affect the service life of the laser tube, it is recommended to use pure water or distilled water, and control the water temperature below 35 ° C.

     3, health, do not underestimate this aspect of the work, because this is still very important, we have to ensure that the surrounding environment is not only clean, but also not a lot of dust, because when the dust into the laser marking machine, it will hinder its operation, but also certain damage to the machine, usually when using the laser marking machine, Also try to reduce the use of lasers, do not turn on when not necessary.

     4, in the use of laser marking machine is to try to stay away from large power and strong vibration equipment sudden large power interference, sometimes cause machine failure, although rare, but should be avoided as far as possible. Therefore, such as large welding machines, giant electric mixers and large power transmission and transformation equipment, should be far away. The strong vibration equipment is more self-evident, such as the forging press, the vibration caused by the walking of close motor vehicles, etc., the obvious shaking of the ground is very unfavorable to the fine engraving.

     Standard operation laser marking machine can make its service life longer, in general, under normal circumstances can use 100,000 hours, in addition to its own life and our usual standard operation can extend the life, in use as far as possible to choose a stable and clean working environment without vibration source, some of the water tank marking machine, regularly clean and replace the water, Use in strict accordance with the manufacturer's instructions for work production.